component of velocity
英 [kəmˈpəʊnənt ɒv vəˈlɒsəti]
美 [kəmˈpoʊnənt əv vəˈlɑːsəti]
【参见】component velocity
双语例句
- What matters is only the radial component of the velocity.
有关的因素只是，速度的辐射成分。 - The component of rotation along the velocity vector is used with the rotary balance test data and other components of the rotation vector are used with the forced oscillation test data.
旋转角速度的其它分量用于振荡天平试验数据，综合地使用了各类试验数据。 - Foggy Weather Feature and Forecast along the Line of Shanxi Speedway A Doppler radar only measures the component of the velocity in the line of sight, the so-called radial velocity.
山西高速公路沿线大雾天气特征及预报服务因为多普勒雷达探测到的仅仅是风矢量在径向上的分量。 - This article has studied the asynchronous motor vector transformation control theory and carries on the speed calculation using the electric motor torque component of current the method, designed a closed loop velocity modulation system not to have the velocity generator.
深入研究了异步电动机矢量变换控制理论和利用电动机转矩电流分量进行速度推算的方法，设计了一个闭环的无速度传感器矢量控制变频调速系统。 - The numerical simulation of gas-phase turbulent flow in furnace is implemented based on k-ε turbulent two-equation model. The deflective circle is rational in terms of simulation results that the vertical component of air-flow velocity to the water-wall at No.
以k-ε双方程湍流模型对炉内气相湍流流动进行数值模拟，发现锅炉2号角的气流速度在垂直该侧炉墙方向分量较大，对水冷壁产生冲刷。 - Finally, we find that the component of relative velocity parallel to the main stream is not equal to zero.
最后我们得到泥沙和水的相对速度在主流方向的分量并不等于零。 - By analyzing mechanism of the influence of ship motion on carrier launching, the vertical component of exit velocity is treated as a key parameter for evaluating launching safety.
通过分析航母运动对舰载机起飞的影响机理，选择飞机离舰爬升率作为评价起飞安全性的关键参数； - The entraining velocity on the contact point of gear surface is studied and the difference between entraining velocity and component of relative velocity in the normal direction of contact line is analyzed.
探讨了齿面接触点上的卷吸速度，并对相对滑动速度在接触线法向的分量和卷吸速度进行了对比研究。 - A Doppler radar only measures the component of the velocity in the line of sight, the so-called radial velocity.
因为多普勒雷达探测到的仅仅是风矢量在径向上的分量。 - When the cam is ground, the tangential component of the circular velocity is variable, and the peak value occurs in the lift curves. This is an important cause of profile error.
凸轮磨削时，圆周速度切线分量是变化的，在升程曲线部分出现峰值，这是导致该部分出现轮廓误差的重要原因。